Loaders of balls

.

When we decided that we needed a loader, we would owe
Carrying the reply to the store to try it right there, if
No, we can get an annoyance when getting home and
Verifying that you do not enter our reception room or than no nos
Hold the eyelash of the sujeccion of the loader well and himself nos
Fall .

Even entering the loader and getting fastened we will can
Finding that you do not feed our balls, not everybody well them
The loaders hold good for all the replies although they tell us
That they are compatible, this is owed to than all them
Hop's bodies do not have the same measures neither them
Loaders the same construction.

The possibility that the loader takes revenge for defective is also
And not feed balls gradually or remain jammed.

First, we filled the loader with balls

Without a lot of noise around we go giving slowly to the roulette and we have to perceive that, for the noise that you do, balls go rising up without no interruption, if you have any one we will find out, because the noise that the balls do when rising is  stopped and instantly the dock hearing again the noise of the balls rising jumps a little.

If this happens I end, it is that the loader does not bait well and you would be able to cause us problems.

In order to put them into the serious copy, the first thing, taking balls, giving to the roulette, until we see them for you arrive to introduce the loader in the reply, giving the roulette, only, ten times and shooting to verify that drunkards are OK from her first, telling the rumors that slip out without hitting but to the roulette.

Once once this was  checked doing the same thing giving 15 times to the roulette and that way even seeing what the loader before failing holds .



Loaders low and mid cap



These are but difficult to check, what it is necessary to take into account of them is the quantity of balls that they can contain, to but balls, but interior dock
At the most dock, have loaders, the first balls, but they will make out force of the hop against the body, could have impeded that those first balls come out right and of one in one .
In order that one understand a little visually, I will put the following photo.



                                                               

                                       Detail of the insides of the loader and of the nozzle that you get and the ball places .

.

There would be not enough the compressed dock in the photo, or to stockings to compress ( But anyone takes him a photograph )

Then we can perceive that the one thing that makes to position the ball within the hop is the force of the dock of the Tapet Plate.
You can think that you can put on a very strong dock, you have reason, it can go down, but probably break the Tapet Plate's back
And we would wear down the plastic piece that grates on with the engranage's levy sector very fast ( that she is the one that the Tapet Plate makes to back away ).


The recommendation that can take place here would be give it, if a loader comes from 80 balls, beginning trying introducing 50, firing a shot and verifying that the balls from her first, if you pass the test, come out all right to introduce but and and so on until we check with All the ones that be possible that they come out all right at the first shot.